Supplemental Restraint Systems

Occupant Classification ECU Malfunction (B1795)

~2min read

DESCRIPTION

DTC B1795 is stored when a malfunction is detected in the occupant detection ECU.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B1795

Occupant Classification ECU Malfunction

Occupant Detection ECU Malfunction

Occupant Detection ECU

PRECAUTION / NOTICE / HINT

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

HINT:

When DTC B1650/32 is stored as a result of airbag system troubleshooting, check the DTCs stored in the occupant detection ECU. When DTC B1795 is output, perform troubleshooting for this DTC first.

PROCEDURE

  1. CHECK DTCs

(a) Clear the DTCs stored in the occupant detection ECU.

Click here

Body Electrical > Occupant Detection > Clear DTCs

(b) Clear the DTCs stored in the airbag sensor assembly.

Click here

Body Electrical > SRS Airbag > Clear DTCs

(c) Turn the ignition switch to OFF.

(d) Turn the ignition switch to ON and wait at least 10 seconds.

(e) Check the DTCs.

Click here

Body Electrical > Occupant Detection > Trouble Codes

OK:

DTC B1795 is not output.

HINT:

Codes other than DTC B1795 may be output at this stage, but they are not related to this check.

(f) Turn the ignition switch to the OFF position.

OK

USE SIMULATION METHOD TO CHECK

NG
  1. REPLACE OCCUPANT DETECTION ECU

(a) Turn the ignition switch OFF.

(b) Disconnect the cable from the negative (-) battery terminal.

(c) Replace the occupant detection ECU.

Click here

(d) Connect the cable to the negative (-) battery terminal.

NEXT
  1. PERFORM ZERO POINT CALIBRATION

(a) Using the Techstream, perform zero point calibration.

Click here

Body Electrical > Occupant Detection > Utility

Zero Point Calibration

NEXT

END