Supplemental Restraint Systems

Yaw Rate Sensor Module Malfunction (B1798,B1799)

~3min read

DESCRIPTION

The occupant detection ECU receives signals from the acceleration sensor (airbag sensor assembly) and the skid control ECU via the CAN communication system.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B1798

Yaw Rate Sensor Module Malfunction

The acceleration signals are not normal.

  • Acceleration Sensor (Airbag Sensor Assembly)
  • CAN communication system
  • Occupant Detection ECU

B1799

Vehicle Stability Control ECU Malfunction

The vehicle speed signal transmitted by the skid control ECU is not normal.

  • Skid control ECU (brake actuator assembly)
  • CAN communication system
  • Occupant Detection ECU

PRECAUTION / NOTICE / HINT

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

HINT:

  • When DTC B1650/32 is stored as a result of airbag system troubleshooting, check the DTCs stored in the occupant detection ECU. When DTC B1798 or B1799 is output, perform troubleshooting for this DTC first.
  • If troubleshooting is difficult (wire harness check), remove the front passenger seat mounting bolts to see underneath the seat cushion.
  • In the case mentioned above, lift and hold the seat so that it does not fall. Only hold the seat if necessary, as holding the seat for a long period may deform the seat rail.

PROCEDURE

  1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

(a) Check for DTCs related to the vehicle stability control system.

Click here

OK:

No DTCs are output.

NG

GO TO VEHICLE STABILITY CONTROL SYSTEM

OK
  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Using the Techstream, check whether the CAN communication system operates normally.

OK:

The CAN communication system operates normally.

HINT:

Refer to the CAN Bus Check section in the CAN communication system.

Click here

NG

GO TO CAN COMMUNICATION SYSTEM

OK
  1. CHECK DTC (HEALTH CHECK)

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON and turn on Techstream.

(d) Select the following menu items: System Select / Health Check.

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

GO TO OTHER DIAGNOSTIC TROUBLE CODE CHART