Precautions
PRECAUTION
GENERAL PRECAUTIONS
(a) The following conditions may be considered a malfunction even though the system is operating normally:
- An object placed on the passenger seat may cause the system to judge that an adult is occupying the seat. Since the occupant classification system detects and classifies occupants based on weight, the system may detect an object placed on the seat cushion as an adult passenger depending on its weight.
- Pressure is applied to the front passenger seat and the system judges that an adult is occupying the seat. Since the occupant classification system detects and classifies occupants based on weight, the system may detect an adult passenger if pressure is applied by hand to the seat cushion, etc.
- The passenger airbag ON/OFF indicator light does not change immediately after a passenger occupying the seat leaves the vehicle. To prevent the classification decision from changing when a passenger changes seating position, a certain amount of time is required to detect and classify an occupant when the calculated weight changes. Therefore, there is a delay between the moment a passenger occupies or leaves the seat and the moment the system detects the occupant.
(b) The occupant classification zero point sensors may deviate under the following conditions. To ensure sensor accuracy, be sure to perform zero point calibration.
- The occupant detection ECU is replaced.
HINT:
Since the zero point is not automatically stored in a new occupant detection ECU, zero point calibration must be performed after replacing the occupant detection ECU.
- Accessories (seatback board and seat cover, etc.) are reinstalled.
HINT:
Since the weight of accessories will be added to the occupant's weight, the system will not be able to perform classification accurately.
- The front passenger seat is removed from the vehicle.
HINT:
Since the seat frame will deform slightly when the bolts used to install the front passenger seat are tightened, the load applied to the occupant classification sensor will change and the system will not be able to classify accurately.
- One of the bolts used to install the front passenger seat is removed and reinstalled.
HINT:
Since the seat frame will deform slightly when the bolts used to install the front passenger seat are tightened, the load applied to the occupant classification sensor will change and the system will not be able to classify accurately.
- The passenger airbag ON/OFF indicator ("ON") illuminates when the front passenger seat is occupied.
HINT:
If pressure or load is applied to the occupant classification sensors, the system will not be able to classify accurately.
- The vehicle is brought to the workshop for repair following an accident or collision.
HINT:
If the seat frame or vehicle floor has deformed and additional pressure is applied to the occupant classification sensor, the system will not be able to classify accurately.
- A DTC related to collision detection of the occupant classification sensor is output following an accident or collision.
IGNITION SWITCH TERMS
(a) The type of ignition switch used differs depending on the vehicle specifications. The terms in the table below are used in this section.
Term | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
Ignition Switch in OFF position |
LOCK |
OFF (Locked) |
Ignition Switch in ACC position |
ACC |
ON (ACC) |
Ignition Switch in ON position |
ON |
ON (IG) |
Starting the engine |
START |
ON (Starting) |