Initialization
INITIALIZATION
DESCRIPTION
(a) The occupant classification zero point sensors may deviate under the following conditions. To ensure sensor accuracy, be sure to perform zero point calibration.
- The occupant detection ECU is replaced.
HINT:
Since the zero point is not automatically stored in a new occupant detection ECU, zero point calibration must be performed after replacing the occupant detection ECU.
- Accessories (seatback board and seat cover, etc.) are reinstalled.
HINT:
Since the weight of accessories will be added to the occupant's weight, the system will not be able to perform classification accurately.
- The front passenger seat is removed from the vehicle.
HINT:
Since the seat frame will deform slightly when the bolts used to install the front passenger seat are tightened, the load applied to the occupant classification sensor will change and the system will not be able to classify accurately.
- One of the bolts used to install the front passenger seat is removed and reinstalled.
HINT:
Since the seat frame will deform slightly when the bolts used to install the front passenger seat are tightened, the load applied to the occupant classification sensor will change and the system will not be able to classify accurately.
- The passenger airbag ON/OFF indicator ("ON") illuminates when the front passenger seat is occupied.
HINT:
If pressure or load is applied to the occupant classification sensors, the system will not be able to classify accurately.
- The vehicle is brought to the workshop for repair following an accident or collision.
HINT:
If the seat frame or vehicle floor has deformed and additional pressure is applied to the occupant classification sensor, the system will not be able to classify accurately.
- A DTC related to collision detection of the occupant classification sensor is output following an accident or collision.
NOTICE:
Before performing this operation, make sure the front passenger seat is unoccupied.
ZERO POINT CALIBRATION
(a) Zero point calibration procedure
(1) Make sure that all of the following conditions are met:
- The vehicle is parked on a level surface.
- The front passenger seat is completely unoccupied.
- No object is touching the front passenger seat.
(2) Adjust the seat position according to the table below.
Adjustment item | Position |
|---|---|
Sliding direction |
Rearmost position |
Headrest height |
Lowest position |
Reclining angle |
Upright position |
(3) Turn the ignition switch to OFF.
(4) Connect the Techstream to the DLC3.
(5) Turn the ignition switch ON.
(6) Turn on the Techstream.
(7) Select the following menu items: Body Electrical / Occupant Detection / Utility / Zero Point Calibration.
Body Electrical > Occupant Detection > UtilityZero Point Calibration
(8) Perform zero point calibration by following the instructions shown on the Techstream screen.
OK:
"Zero Point Calibration is complete." is displayed.
HINT:
- Refer to the Techstream operator's manual for more information.
- If zero point calibration does not complete normally, perform the procedure again. If zero point calibration cannot be performed correctly, replace the front RH seat adjuster assembly.