Door Lock

How to Use Troubleshooting

~3min read

PRECAUTION / NOTICE / HINT

HINT:

  • The troubleshooting procedures for the remote door lock system assume that the central door locking system operates correctly. Check the central door locking system first before troubleshooting the remote door lock system. Troubleshooting procedure for the remote door lock system.
  • *: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS SHEET

HINT:

  • When troubleshooting, make sure the symptoms of the problem have been correctly identified. Any preconceptions must be set aside in order to make an accurate judgment. To clearly understand the actual symptoms of the problem, it is essential to ask the customer about the nature of the problem and the conditions under which it occurred.
  • Gather as much information as possible for reference. Previous problems that do not appear related to the current problem may also be very useful in some cases.
  • The following 5 elements are essential for analyzing the problem:

What

Vehicle model, system name

When

Date, time, frequency of occurrence, whether the problem appeared recently or has been occurring for a long time

Where

If the problem occurs at a specific location

What were the conditions?

Check whether the doors are locked or unlocked, whether the ignition switch is in the ON position, and whether the engine has started.

How did it happen?

Problem Symptoms

NEXT
  1. PRELIMINARY CHECKS

(a) Measure the battery voltage.

Standard voltage:

11 à 14 V

If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.

(b) Check the fuses and relays.

(c) Check the connectors and terminals for any abnormality, such as loose connections, deformation, etc.

NEXT
  1. CHECK CAN COMMUNICATION SYSTEM FUNCTION*

(a) Using the Techstream, check for DTCs related to the CAN communication system.

Click here

Result:

Result

Proceed to

No CAN system DTCs are output

A

CAN-related DTCs are output

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTC (REMOTE DOOR LOCKING SYSTEM)*

(a) Clear the DTCs.

Click here

Body Electrical > Smart Key > Clear DTCs

(b) Check the DTCs again.

Body Electrical > Smart Key > Trouble Codes

Result:

Result

Proceed to

No DTCs are output

A

DTCs are output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A
  1. SYMPTOM TROUBLESHOOTING TABLE

(a) Refer to the Symptom Troubleshooting Table.

Click here

Result:

Result

Proceed to

The malfunction is not listed in the Problem Symptoms Table

A

The malfunction is listed in the Problem Symptoms Table

B

B

GO TO STEP 8

A
  1. GENERAL ANALYSIS AND TROUBLESHOOTING*

(a) ECU terminals

Click here

(b) Data List/Active Test

Click here

(c) Operation Check

Click here

(d) Check

NEXT
  1. REPAIR OR REPLACE

NEXT
  1. CONFIRMATION TEST

NEXT

END