3zr-fae Battery / Charging

How to Use Troubleshooting

~2min read

PRECAUTION / NOTICE / HINT

HINT:

*: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS

HINT:

  • When troubleshooting, make sure the symptoms of the problem have been correctly identified. Any preconceptions must be set aside in order to make an accurate judgment. To clearly understand the actual symptoms of the problem, it is essential to ask the customer about the nature of the problem and the conditions under which it occurred.
  • Gather as much information as possible for reference. Previous problems that do not appear related to the current problem may also be very useful in some cases.
  • The following 5 elements are essential for analyzing the problem:

    What

    Vehicle model, system name

    When

    Date, time, frequency of occurrence

    Where

    Road conditions

    What were the conditions?

    Driving conditions, driving habits, weather conditions

    How did it happen?

    Problem Symptoms

NEXT
  1. CHECK BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 à 14 V

If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.

NEXT
  1. CHECK CAN COMMUNICATION SYSTEM FUNCTION*

(a) Check whether CAN communication system DTCs are output.

Click here

Result:

Result

Proceed to

CAN communication DTCs are not output.

A

CAN communication DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTCs*

HINT:

Refer to Check / Clear DTCs.

Click here

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

GO TO DTC CHART

A
  1. REFER TO SYMPTOM TROUBLESHOOTING TABLE

HINT:

Refer to the symptom troubleshooting table.

Click here

Result:

Result

Proceed to

No defective parts confirmed.

A

Defective parts confirmed.

B

B

GO TO STEP 12

A
  1. GENERAL ANALYSIS AND TROUBLESHOOTING*

HINT:

Refer to the Data List / Active Test item.

Click here

Result:

Result

Proceed to

No defective parts confirmed.

A

Defective parts confirmed.

B

B

GO TO STEP 12

A
  1. CHECK ECM CIRCUIT

HINT:

Refer to the ECM terminals item.

Click here

NG

GO TO STEP 12

OK
  1. CHECK FOR INTERMITTENT PROBLEMS

HINT:

Refer to the symptom simulation.

Click here

NEXT
  1. CHECK COMPONENT PARTS

NEXT
  1. IDENTIFY THE PROBLEM

NEXT
  1. ADJUST AND/OR REPAIR

NEXT
  1. PERFORM CONFIRMATION TEST

NEXT

END