3zr-fae Battery / Charging

Charging malfunction

~2min read

PROCEDURE

  1. CHECK ALTERNATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION)

(a) Start the engine and visually check whether the generator (fan) rotor assembly in the generator assembly operates.

OK:

The generator (fan) rotor assembly operates.

NG

REPLACE GENERATOR PULLEY WITH CLUTCH

OK
  1. INSPECT GENERATOR PULLEY WITH CLUTCH (INSPECTION UNIT)

(a) Remove the generator assembly.

Click here

(b) Check the installation condition of the generator pulley cover.

OK:

The generator pulley cap is not loose and no parts are missing.

(c) Make sure there is no particle formation due to friction (for dry-type pulley) or grease leakage (for wet-type pulley).

OK:

There are no large amounts of particles (for dry-type pulley) or grease leakage (for wet-type pulley).

(d) Check that the generator pulley with clutch is correctly aligned (no interference with the generator assembly).

OK:

The generator pulley with clutch is not misaligned (no interference with the generator assembly).

(e) Turn the generator pulley with clutch by hand clockwise and counterclockwise, and check for noise.

OK:

No noise is produced when turning it in either direction.

(f) Turn the generator pulley with clutch by hand clockwise and counterclockwise, and visually check for out-of-round (ovality).

OK:

The generator pulley with clutch is not out-of-round.

(g) Hold the generator (fan) rotor assembly in place at the generator assembly using a screwdriver whose tip has been wrapped in protective tape, and make sure the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.

OK:

The generator pulley with clutch locks when turned clockwise and moves freely when turned counterclockwise.

*a

Protective tape

OK

REPAIR OR REPLACE GENERATOR ASSEMBLY

NG

REPLACE GENERATOR PULLEY WITH CLUTCH