3zr-fae Battery / Charging

Freeze Frame Data

~2min read

FREEZE FRAME DATA

DESCRIPTION

The ECM records vehicle and driving condition information as freeze frame data at the time a DTC is stored. When troubleshooting, freeze frame data can help determine whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, and can help verify other data recorded at the time of the malfunction.

HINT:

If the symptoms cannot be reproduced even though a DTC is stored, check the freeze frame data.

PENDING FREEZE FRAME DATA

HINT:

Pending freeze frame data is stored when a 2-trip DTC is first detected during the first trip.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes

(e) Select a DTC to display its pending freeze frame data.

HINT:

  • Pending freeze frame data is erased when any of the following conditions is met:
    • DTCs are erased using the Techstream.
    • The cable is disconnected from the negative (-) battery terminal.
    • 40 driving cycles have been completed with the engine fully warmed up after the condition has returned to normal. (Pending freeze frame data will not be erased simply because the system returns to normal.)
  • If new pending freeze frame data is stored when a 2-trip DTC is detected during the first trip while pending freeze frame data was previously stored, the oldest freeze frame data is replaced by the new data corresponding to the newly detected DTC in the following trip.

FREEZE FRAME DATA LIST

Powertrain > Engine and ECT

Tester display

Battery Voltage

Alternator Output Duty

Alt Vol - Non Active Test

Alt Vol - Active Test