Removal
REMOVAL
PROCEDURE
1. REMOVE RADIATOR GRILLE
(a) Remove the 2 hood cushion stoppers. |
![]() |
(b) Remove the 4 clips.
(c) Release the guides to remove the radiator grille as shown in the illustration.
![]() |
Remove in this direction |
2. DETACH LEFT FRONT FENDER MOULDING SUBASSEMBLY
(a) Place protective masking tape around the left front fender moulding subassembly.
![]() |
Protective tape |
(b) Remove the 3 screws.
(c) Remove the 2 clips.
(d) Using a screwdriver, turn the pin 90 degrees and remove the pin retainer clip. HINT: Repeat the same procedure for the right side and the left side. |
|
(e) Pull the rear edge of the left front fender liner and release the claws by pushing the area indicated by the arrow in the illustration with your finger.
![]() |
Place hands here |
![]() |
Remove in this direction |
NOTICE:
- Do not apply excessive force when pulling the left front fender liner rearward.
- To avoid damaging the claws, do not pull the left front fender moulding subassembly with excessive force.
(f) Release the clips and detach the left front fender moulding subassembly.
3. DETACH RIGHT FRONT FENDER MOULDING SUBASSEMBLY
HINT:
Perform the same procedure as for the left side.
4. REMOVE FRONT BUMPER ASSEMBLY
(a) Place protective masking tape around the front bumper assembly.
![]() |
Protective tape |
HINT:
Repeat the same procedure for the right side and the left side.
(b) Remove the 3 bolts. |
![]() |
(c) Remove the 6 screws. |
![]() |
(d) Release the claws as shown in the illustration.
![]() |
Place hands here |
![]() |
Remove in this direction |
HINT:
Repeat the same procedure for the right side and the left side.
(e) with fog lights:
(1) Pull the side of the front bumper assembly rearward and disconnect the connector.
NOTICE:
Do not apply excessive force when pulling the front bumper assembly.
HINT:
Repeat the same procedure for the right side and the left side.
![]() |
Remove in this direction |
(f) with Toyota Safety Sense: (1) Disconnect the connector. |
![]() |
(g) Release the claw to remove the front bumper assembly as shown in the illustration.
![]() |
Remove in this direction |

.png)
.png)

.png)


