Exterior Panels / Trim

Installation

~2min read

INSTALLATION

PROCEDURE

1. INSTALL FRONT BUMPER ASSEMBLY

(a) Move the front bumper assembly into position.

(b) With Toyota Safety Sense system:

(1) Connect the connector.

(c) Temporarily install the front bumper assembly using the claw, as shown in the illustration.

Install in this direction

(d) With fog lights:

(1) Pull the side of the front bumper assembly rearward and connect the connector.

NOTICE:

Do not apply excessive force when pulling the front bumper assembly.

HINT:

Repeat the same procedure for the right side and the left side.

(e) Engage the claws as shown in the illustration.

HINT:

Repeat the same procedure for the right side and the left side.

Install in this direction

(f) Install the 6 screws.

(g) Install the pin clip as shown in the illustration.

NOTICE:

Insert the pin retaining clip using the vertically aligned groove.

Do not rotate the clip after inserting it.

After installation, make sure the groove is aligned vertically.

HINT:

Repeat the same procedure for the right side and the left side.

*a

Correct

*b

Incorrect

(h) Install the 3 bolts.

(i) Remove the protective tape.

2. INSTALL FRONT FENDER APRON MOULDING SUB-ASSEMBLY LH

(a) Engage the clip and claws to install the front fender apron moulding sub-assembly LH.

Install in this direction

(b) Install the 3 screws.

(c) Install the 2 clips.

(d) Remove the protective tape.

3. INSTALL FRONT FENDER APRON MOULDING SUB-ASSEMBLY RH

HINT:

Perform the same procedure as for the left side.

4. INSTALL RADIATOR GRILLE COVER

(a) Engage the guides to install the radiator grille cover as shown in the illustration.

Install in this direction

(b) Install the 4 clips.

(c) Install the 2 hood bumper stoppers.

5. ADJUST FOG LIGHT ASSEMBLY

Click here