Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization or registration) after the parts are removed, installed, or replaced during No. 1 cooler thermistor removal/installation are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
|
Pre-Collision System |
|||
Initialize Back Door Lock |
Door Lock Control System |
||
No. 1 Air Conditioning Radiator Door Servo Sub-assembly. |
Initialize Servo Motor (Air Conditioning System) |
DTCs are stored |
PROCEDURE
1. REMOVE BLOWER ASSEMBLY
Click here![]()
2. REMOVE AIR CONDITIONING WIRE HARNESS ASSEMBLY
Click here![]()
3. REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
Click here![]()
4. REMOVE HEATER HOSE GROMMET
Click here![]()
5. REMOVE HEATER CLAMP
Click here![]()
6. REMOVE HEATER CORE SUB-ASSEMBLY
Click here![]()
7. REMOVE COOLER EXPANSION VALVE
Click here![]()
8. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Click here![]()
9. REMOVE NO. 1 COOLER THERMISTOR
(a) Remove the No. 1 cooler thermistor. |
![]() |
.gif)
