Theft Deterrent / Keyless Entry

Relay

~1min read

Inspection

INSPECTION

PROCEDURE

1. INSPECT SECURITY WARNING RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Ignition switch position

Specified Condition

3 - 5

Battery voltage applied to terminals 1 and 2

Below 1 Ω

3 - 5

Battery voltage is not applied to terminals 1 and 2

10 kΩ minimum

  • If the result is not as specified, replace the security warning relay.