Exterior Panels / Trim

Reassembly

~2min read

REASSEMBLY

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. INSTALL BODY OUTSIDE MOULDING CUSHION NO. 1

HINT:

When installing the body outside moulding cushion No. 1, heat the quarter outside moulding using a heat lamp.

CAUTION:

  • Do not touch heated parts or the heat lamp. Touching them may cause burns.

    *a

    Hot Surface

    *b

    Heat Lamp

  • Prolonged contact with heated parts may cause burns.

Standard:

Item

Temperature

Quarter outside moulding

20 à 30 °C

NOTICE:

Do not overheat the quarter outside moulding.

(a) Clean the body outside moulding cushion No. 1 installation surface using residue-free solvent.

(b) Apply primer to the body outside moulding cushion No. 1 on the quarter outside moulding subassembly installation area.

NOTICE:

Apply primer evenly so that there are no uncoated areas.

(c) Remove the release paper from a new body outside moulding cushion No. 1, taking care not to touch the adhesive surface.

(d) Install a body outside moulding cushion No. 1 in the position shown in the illustration.

NOTICE:

  • Press the double-sided adhesive tape firmly onto the body outside moulding cushion No. 1 to secure it.
  • When the primer is dry (at least 3 minutes), install the body outside moulding cushion No. 1.
  • After applying primer, apply a second coat of primer 24 hours later.

*1

Alignment Line

*a

5.0 mm (0.197 in.)

*b

2.0 mm (0.0787 in.)

*c

8.0 mm (0.315 in.)

*d

1.6 mm (0.0630 in.)