Heater / Air Conditioning

Installation

~1min read
010203040509.87N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL AIR CONDITIONING PRESSURE SENSOR (VALEO make)

(a) Remove the vinyl tape from the cooler refrigerant liquid tube A.

(b) Apply a sufficient amount of compressor oil to a new air conditioning pressure sensor and to the mating surface of the air conditioning pressure sensor.

Compressor oil:

VC100YF or equivalent

(c) Using a 27 mm long socket wrench, install the air conditioning pressure sensor as shown in the illustration.

Torque:

9.8 N·m {100 kgf·cm, 87 in·lbf}

*a

Turn

*b

Hold

(d) Connect the connector.

2. INSTALL AIR CONDITIONING PRESSURE SENSOR (Denso Manufactured)

(a) Remove the vinyl tape from the cooler refrigerant liquid tube A.

(b) Apply a sufficient amount of compressor oil to a new air conditioning pressure sensor and to the mating surface of the air conditioning pressure sensor.

Compressor oil:

ND-OIL 12 or equivalent

(c) Using a 27 mm long socket wrench, install the air conditioning pressure sensor as shown in the illustration.

Torque:

10.8 N·m {110 kgf·cm, 8 ft·lbf}

*a

Turn

*b

Hold

(d) Connect the connector.

3. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT (for HFC-134a (R134a))

Click here

4. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT (for HFO-1234yf (R1234yf))

Click here

5. WARM UP ENGINE (for HFC-134a (R134a))

Click here

6. WARM UP ENGINE (for HFO-1234yf (R1234yf))

Click here

7. CHECK FOR REFRIGERANT LEAK (for HFC-134a (R134a))

Click here

8. CHECK FOR REFRIGERANT LEAK (for HFO-1234yf (R1234yf))

Click here