K114 Continuously Variable Transmission

Installation

~2min read
01020304050129N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL FLOOR SHIFT LEVER ASSEMBLY

(a) Temporarily install the floor shift lever assembly to the body using 4 bolts.

(b) Fully tighten the 4 bolts in the order shown in the illustration.

Torque:

12 N·m {122 kgf·cm, 9 ft·lbf}

(c) Engage the 6 clips to install the wire harness on the floor shift lever assembly.

(d) Connect the 2 connectors to the floor shift lever assembly.

2. CONNECT CONTROL CABLE ASSEMBLY

(a) Install the transmission control cable assembly on the floor shift lever assembly.

Install in this direction

NOTICE:

Make sure the shift control cable assembly is securely locked.

Install in this direction

(b) Connect the end of the transmission control cable assembly to the floor shift lever assembly.

NOTICE:

  • Before connecting the shift control cable assembly, make sure the park/neutral position switch and the shift lever are in the N position.
  • Install the end of the shift control cable assembly so that the lock piece faces the driver side.
  • Fully install the end of the shift control cable assembly to the base of the pin.

3. INSTALL NO. 1 CONSOLE BOX BRACKET

(a) Install the No. 1 console box bracket to the vehicle body with the 2 bolts.

(b) Engage the 3 clips to install the wire harness on the No. 1 console box bracket.

4. ADJUST SHIFT LEVER POSITION

Click here

5. INSTALL CONSOLE BOX ASSEMBLY

Click here

6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Click here

7. INSTALL SHIFT LEVER KNOB CAP

(a) Engage the 2 claws to install the shift lever knob cap on the instrument panel garnish.

8. CHECK SHIFT LEVER POSITION

Click here