Back Door Courtesy Switch Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) receives a back door open/closed signal from the back door courtesy light switch (back door lock assembly).
WIRING DIAGRAM
NOTICE:
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.*1
for HEV Model: Click here ![]()
for Gasoline Model: Click here ![]()
- *1: w/ Smart Key System
PROCEDURE
READ VALUE USING GTS
(a) Read the Data List according to the display on the GTS.
Body Electrical > Main Body > Data ListTester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
Back Door Courtesy Switch Status |
Back door courtesy switch signal |
CLOSE or OPEN |
CLOSE: Back door closed OPEN: Back door open |
- |
Back Door Courtesy Switch Status
OK:
Normal conditions listed above are displayed.
| OK | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
INSPECT BACK DOOR COURTESY LIGHT SWITCH (BACK DOOR LOCK ASSEMBLY)
Click here ![]()
| NG | REPLACE BACK DOOR COURTESY LIGHT SWITCH (BACK DOOR LOCK ASSEMBLY) |
|
CHECK HARNESS AND CONNECTOR (BACK DOOR COURTESY LIGHT SWITCH (BACK DOOR LOCK ASSEMBLY) - POWER DISTRIBUTION BOX ASSEMBLY AND BODY GROUND)
(a) Disconnect the 8F power distribution box assembly connector.
(b) Disconnect the U42 multiplex network door ECU connector.*1
- *1: w/ Power Back Door System
(c) Measure the resistance according to the value (s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
U4-3 (D+) - 8F-2 |
Always |
Below 1 Ω |
U4-2 (ACT-) - Body ground |
Always |
Below 1 Ω |
U4-3 (D+) - Body ground |
Always |
10 kΩ or higher |
8F-2 - Body ground |
Always |
10 kΩ or higher |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
INSPECT POWER DISTRIBUTION BOX ASSEMBLY
*a |
Component without harness connected (Power Distribution Box Assembly) |
- |
- |
(a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly.
Click here ![]()
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
8F-2 - MB-19 (BCTY) |
Always |
Below 1 Ω |
| OK | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG | REPLACE POWER DISTRIBUTION BOX ASSEMBLY |