Toyota Land Cruiser Quiz
Automatic Transmission

Inspection

In this manual: Automatic Transmission
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read

1. INSPECT SHIFT LOCK CONTROL ECU

INSPECT SHIFT LOCK CONTROL ECU

Using a voltmeter, measure the voltage at each terminal.

HINT: Do not disconnect the ECU connector.

INSPECT SHIFT LOCK CONTROL ECU

2. INSPECT SHIFT LOCK SOLENOID

INSPECT SHIFT LOCK SOLENOID
(a) Disconnect the solenoid connector.

(b) Using an ohmmeter, measure the resistance between terminal 1 and 2.

Standard resistance: 21 - 27 W

If the resistance value is not as specified, replace the solenoid.

(c) Apply the battery positive voltage between terminals.

Check that the operation noise can be heard from the solenoid.

If the solenoid does not operate, replace the solenoid.

3. INSPECT SHIFT LOCK CONTROL SWITCH

Inspect that continuity exists between each terminal.

INSPECT SHIFT LOCK CONTROL SWITCH

If continuity is not as specified, replace the switch.

4. INSPECT KEY INTERLOCK SOLENOID

INSPECT KEY INTERLOCK SOLENOID
(a) Disconnect the solenoid connector.

(b) Using an ohmmeter, measure the resistance between terminal 1 and 2.

Standard resistance: 12 - 17 W

If resistance value is not as specified, replace the solenoid.

(c) Apply the battery positive voltage between terminals 1 and 2. Check that an operation noise can be heard from the solenoid.

If the solenoid does not operate, replace the solenoid.

Shift lock system

LOCATION

LOCATION

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.