Toyota Land Cruiser Quiz
Body Electrical

Installation

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read
010203040504.94N·mlb·ft
Tightening torque found on this page

NOTICE:

  • Never use seat belt pretensioner from another vehicle.

    When replacing parts, replace them with new parts.

  • Make sure that the front seat outer belt is installed with the specified torque.
  • If the front seat outer belt has been dropped, or there are cracks, dents or other defects in the case or connector, replace the front seat outer belt with a new one.
  • When installing the front seat outer belt, take care that the wiring does not interfere with other parts and is not pinched between other parts.

1. INSTALL RETRACTOR OF FRONT SEAT OUTER BELT

(a) Install the retractor of front seat outer belt with the bolt.

Torque: Upper bolt: 4,9 N·m

INSTALL RETRACTOR OF FRONT SEAT OUTER BELT

(b) Connect the pretensioner connector in the order "A" and "B" as shown in the illustration.

2. INSTALL FRONT SEAT OUTER BELT SHOULDER ANCHOR

Torque: 43 N·m

3. INSTALL FRONT SEAT OUTER BELT FLOOR ANCHOR

Torque: 43 N·m

4. INSTALL CENTER PILLAR LOWER GARNISH

INSTALL CENTER PILLAR LOWER GARNISH
(a) Install the center pillar lower garnish.

(b) Install the center pillar garnish cover.

5. INSTALL REAR DOOR OPENING TRIM

6. INSTALL REAR DOOR SCUFF PLATE

7. INSTALL FRONT DOOR OPENING TRIM

8. INSTALL FRONT DOOR SCUFF PLATE

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.