Toyota Land Cruiser Quiz
Body Electrical

Knock sensor

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read
1special tools
0204060801004533N·mlb·ft
Tightening torque found on this page

COMPONENTS

COMPONENTS
COMPONENTS

Inspection

1. REMOVE V-BANK COVER

2. REMOVE INTAKE AIR CONNECTOR

3. DISCONNECT THROTTLE BODY FROM INTAKE MANIFOLDS (SF-50 )

4. REMOVE UPPER AND LOWER INTAKE MANIFOLDS ASSEMBLY (EM-35 )

5. INSPECT KNOCK SENSOR 1, 2

INSPECT KNOCK SENSOR 1, 2

(a) Disconnect the knock sensor connectors.

(b) Using an ohmmeter, check that there is no continuity between the terminal and body.

INSPECT KNOCK SENSOR 1, 2

If there is a continuity, replace the sensor with SST.

SST 09816-30010

Torque: 45 N·m

(c) Reconnect the knock sensor connectors.

6. REINSTALL UPPER AND LOWER INTAKE MANIFOLDS ASSEMBLY (EM-59 )

7. REINSTALL THROTTLE BODY TO INTAKE MANIFOLDS (SF-50 )

8. REINSTALL INTAKE AIR CONNECTOR

9. REINSTALL V-BANK COVER

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.