Toyota Land Cruiser Quiz
Body Electrical

Removal

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~2min read

1. REMOVE OUTSIDE FRONT FENDER MOULDING

REMOVE OUTSIDE FRONT FENDER MOULDING
(a) Remove the screw.

(b) Using a heat light, heat the moulding to 40 - 60 C (104 - 140 F).

NOTICE: Do not heat the moulding excessively.

(c) Cut the adhesive tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Do not damage the body.

(d) Using a screwdriver, remove the moulding.

HINT: Tape the screwdriver tip before use.

2. REMOVE OUTSIDE FRONT DOOR MOULDING

REMOVE OUTSIDE FRONT DOOR MOULDING

(a) Using a heat light, heat the moulding to 40 - 60 C (104 - 140 F).

NOTICE: Do not heat the moulding excessively.

(b) Cut the adhesive tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Do not damage the body.

(c) Using a screwdriver, remove the moulding.

HINT: Tape the screwdriver tip before use.

3. REMOVE OUTSIDE REAR DOOR MOULDING

REMOVE OUTSIDE REAR DOOR MOULDING

(a) Using a heat light, heat the moulding to 40 - 60 C (104 - 140 F).

NOTICE: Do not heat the moulding excessively.

(b) Cut the adhesive tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Do not damage the body.

(c) Using a screwdriver, remove the moulding.

HINT: Tape the screwdriver tip before use.

4. REMOVE UPPER REAR OUTSIDE REAR DOOR MOULDING

REMOVE UPPER REAR OUTSIDE REAR DOOR MOULDING

(a) Using a heat light, heat the moulding to 40 - 60 C (104 - 140F).

NOTICE: Do not heat the moulding excessively.

(b) Cut the adhesive tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Do not damage the body.

(c) Remove the moulding.

5. REMOVE OUTSIDE QUARTER MOULDING

REMOVE OUTSIDE QUARTER MOULDING

(a) Using a heat light, heat the moulding to 40 - 60 C (104 - 140 F).

NOTICE: Do not heat the moulding excessively.

(b) Cut the adhesive tape with a knife.

NOTICE:

  • If reusing the moulding, take care not to damage the moulding.
  • Do not damage the body.

(c) Using a screwdriver, remove the moulding.

HINT: Tape the screwdriver tip before use.

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.