Cargo Light

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE

1. REMOVE ROOF HEADLINING ASSEMBLY

• for Double Cab:

  (See page )

• for Access Cab:

  (See page )

2. REMOVE CARGO LIGHT ASSEMBLY (CENTER STOP LIGHT ASSEMBLY)

(a) Remove the 2 nuts.

(b) Apply protective tape around the cargo light assembly (center stop light assembly).

Text in Illustration

Protective Tape

(c) Using a moulding remover D, disengage the 2 clips to separate the cargo light assembly (center stop light assembly).

(d) Disconnect the connector to remove the cargo light assembly (center stop light assembly).

Inspection INSPECTION PROCEDURE

1. INSPECT CARGO LIGHT ASSEMBLY (CENTER STOP LIGHT ASSEMBLY)

(a) Check the illuminates.

(1) Apply battery voltage to the connector and check the light illumination condition. Text in Illustration *a Component without harness connected (Cargo Light Assembly (Center Stop Light Assembly)) OK: Measurement Condition Specified Condition Battery positive (+) → 3 (DL) Battery negative (-) → 1 (E) Cargo light illuminates If the result is not as specified, replace the cargo light assembly (center stop light assembly).

Installation INSTALLATION PROCEDURE

1. INSTALL CARGO LIGHT ASSEMBLY (CENTER STOP LIGHT ASSEMBLY)

(a) Connect the connector.

(b) Engage the 2 clips to install the cargo light assembly (center stop light assembly).

(c) Install the 2 nuts.

Torque:

3,6 N·m {36 kgf·cm, 31 in·lbf}

(d) Remove the protective tape.

2. INSPECT ROOF HEADLINING ASSEMBLY

• for Double Cab:

  (See page )

• for Access Cab:

  (See page )