Toyota Tacoma Quiz
Lighting

Vanity Light

In this manual: Lighting
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
Components COMPONENTS ILLUSTRATION Removal Removal REMOVAL CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the LH and RH side.
  • The procedures listed below are for the LH side.
PROCEDURE

1. REMOVE VISOR ASSEMBLY

(a) Disengage the guide to separate the visor shaft.

(b) Remove the 2 screws.

(c) Disengage the clip to separate the visor assembly.

(d) Disconnect the connector to remove the visor assembly.

2. REMOVE VANITY LIGHT BULB

(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and 2 guides to remove the front lens holder LH and front lens holder RH.

Text in Illustration

*a

Protective Tape

(b) Remove the 2 vanity light bulbs from the visor assembly.
Installation INSTALLATION CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the LH and RH side.
  • The procedures listed below are for the LH side.
PROCEDURE

1. INSTALL VANITY LIGHT BULB

(a) Install the 2 vanity light bulbs to the visor assembly.

(b) Engage the 2 guides and 2 claws to install the front lens holder LH and front lens holder RH.

2. INSTALL VISOR ASSEMBLY

(a) Connect the connector.

(b) Engage the clip to install the visor assembly.

(c) Install the 2 screws.

(d) Engage the guide to install the visor shaft.

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.