Toyota Tacoma Quiz
Lighting

Room Light Assembly

In this manual: Lighting
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
Components COMPONENTS ILLUSTRATION Removal Removal REMOVAL PROCEDURE

1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY

(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws to remove the No. 1 room light lens.

Text in Illustration

*a

Protective Tape

(b) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and 2 guides to separate the No. 1 room light housing as shown in the illustration.

Text in Illustration

*a

Protective Tape

Push

(c) Disengage the guide to separate the wire harness.

(d) Disengage the 4 claws to separate the No. 1 room light housing from the room light switch base.

2. REMOVE NO. 1 ROOM LIGHT BULB

(a) Remove the No. 1 room light bulb.

Installation INSTALLATION PROCEDURE

1. INSTALL NO. 1 ROOM LIGHT BULB

(a) Install the No. 1 room light bulb.

2. INSTALL NO. 1 ROOM LIGHT ASSEMBLY

(a) Engage the 4 claws to install the No. 1 room light housing to the room light switch base.

(b) Engage the guide to install the wire harness.

(c) Engage the 2 guides and 2 claws to install the No. 1 room light housing.

(d) Engage the 4 claws to install the No. 1 room light lens.

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.