Toyota Tacoma Quiz
Lighting

Cargo Light Switch

In this manual: Lighting
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
Components COMPONENTS ILLUSTRATION Inspection Inspection INSPECTION PROCEDURE

1. INSPECT DECK LIGHT SWITCH ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(Deck Light Switch Assembly)

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

5 (CCTY) - 9 (CGON)

Deck light switch ON

Below 1 Ω

deck light switch DOOR

deck light switch OFF

10 kΩ or higher

10 (CGLP) - 7 (E)

deck light switch ON

Below 1 Ω

deck light switch DOOR

10 kΩ or higher

deck light switch OFF

If the result is not as specified, replace the deck light switch assembly.

(b) Check the illumination.

(1) Apply battery voltage to the connector and check the illumination condition.

Text in Illustration

*a

Component without harness connected

(Deck Light Switch Assembly)

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 1 (ILL+)

Battery negative (-) → Terminal 4 (ILL-)

Illuminates

If the result is not as specified, replace the deck light switch assembly.
Installation INSTALLATION PROCEDURE

1. INSTALL DECK LIGHT SWITCH ASSEMBLY

(a) Engage the 2 claws to install the deck light switch assembly.

2. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

(See page ) ) )

Removal REMOVAL PROCEDURE

1. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

(See page ) ) )

2. REMOVE DECK LIGHT SWITCH ASSEMBLY

(a) Disengage the 2 claws to remove the deck light switch assembly.

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.