Lighting
Rear Door Courtesy Switch
In this manual: Lighting
~1min read
Inspection INSPECTION PROCEDURE
1. INSPECT REAR DOOR COURTESY SWITCH
(a) Check the resistance.
(1) Measure the resistance using an ohmmeter, and check the results in accordance with the value( s) in the table below.
Standard:
Tester Connection | Condition | Specified Condition |
|---|---|---|
1-Switch body |
ON (When shaft is pressed) |
10 kΩ or higher |
1-Switch body |
OFF (When shaft is not pressed) |
Below 1 Ω |
If the result is not as specified, replace the rear door courtesy light switch assembly.
Test yourself
A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?