Removing and installing handle for seat height adjustment

The handle for seat height adjustment can be renewed with front seat installed.

Removing

• Remove handle for seat height adjustment as described. Do not knock handle for seat height adjustment off lever.

• If the tab is damaged when the handle for seat height adjustment is removed, the handle cannot be refitted. The handle for seat height adjustment has to be renewed then.

• Pull handle for seat height adjustment -1- as far as possible upwards and hold it in this position.
• Guide a small screwdriver through handle for seat height adjustment -1- and trim -2- up to catch -3-.
• Push locking lug -3- inwards using screwdriver.
• Simultaneously pull handle for seat height adjustment -1- in -direction of arrow- off lever -4-.

Installing

Install in reverse order, but note the following:

• Check retaining clip -3- for damage and ensure it is properly seated on lever -4-.
• Slide handle for seat height adjustment -1- onto lever -4- until it engages.
• After installing, ensure that retaining clip -4- is properly engaged.
• Check firm seating by pulling on it.