Volkswagen Golf Quiz
General body repairs, interior

Removing and installing memory block

In this manual: General body repairs, interior
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Removing

  • Move front seat to rearmost and highest position.
  • Release backrest and fold it towards front. At the same time move front seat to foremost position.
  • Unscrew rear bolt from seat rail on tunnel side → Chapter.
  • Push locking lever -arrow A- of memory block in -direction of arrow- and pull memory block towards rear.
  • Slightly lift up memory block -1- at rear using a screwdriver and pull it towards rear out of seat rail -2-.
Removing and installing memory block

Installing

  • If the memory block has been renewed, remove all residues from the old memory block in the respective area of the seat rail.
  • Insert memory block -2- into seat rail -1-.
  • Engage memory block in rearmost detent hole -arrow-.
Note

The memory block must not be adjusted.

Further installation is performed in reverse order of removal
Removing and installing memory block

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.