Guide Wheels, Tyres - General Information

Component overview

24steps
~144min
4/5difficulty
Done 0 of 24

Installation overview - Wheel

Installation overview - Wheel, conventional

VW UP. Ratgeber Räder, Reifen - Allgemeine Informationen

  1. Wheel
    • Fitting the wheel
  2. Wheel bolts
    • different versions
  3. Tyres
    • "Information on tyres"
  4. Valve/sensor for tyre pressure
    • Always replace valve
    • Only install valve as per → Electronic Parts Catalogue "ETKA"
    • "Tyre pressure sensor"
  5. Rim
    • Observe installation notes
    • "Information on rims"
    • "Design - rim"
  6. Adhesive balance weights
    • Maximum 60 grams per rim flange permitted
    • Clean the wheel at the bonding point so it is free of dirt and grease
    • Remove protective film
    • Stick balance weights to the designated areas
  7. Anti-theft wheel bolt
    • Observe installation notes
    • Handling
  8. Adapter for anti-theft wheel bolt
    • Fit onto wheel bolt
  9. Cover cap for anti-theft wheel bolts
  10. Cover caps for wheel bolts
  11. Wheel bolts
    • Tightening torque: → Suspension, axles, steering.

Note

Make sure the correct wheel bolts are fitted → Electronic Parts Catalogue "ETKA"

Observe installation notes
  1. Hub cover
    • Remove and install

Installation overview - Wheel, PAX

VW UP. Ratgeber Räder, Reifen - Allgemeine Informationen

  1. Wheel
    • Fitting the wheel
  2. Wheel bolts
    • different versions
  3. PAX tyres
    • Marking on the tyre sidewall
  4. Support ring
  5. Wheel for PAX tyres
    • Observe installation notes
  6. Metal valve body
    • Only install valve as per → ETKA
    • Supplied complete
  7. Wheel electronics
    • Batteries must be replaced completely
    • Remaining service life, temperature and air pressure can be read out via diagnosis with the Vehicle Diagnostic, Measurement and Information System -VAS 5051-

Wheel electronics system Beru

Wheel electronics system Siemens

  1. Adhesive balance weights
    • Maximum 60 grams per rim permitted
    • Clean the wheel at the bonding point so it is free of dirt and grease
    • Remove protective film
    • Stick balance weights to the designated areas
  2. Anti-theft wheel bolt
    • Observe installation notes
    • Handling
  3. Adapter for anti-theft wheel bolt
    • Fit onto wheel bolt
  4. Cover cap for anti-theft wheel bolts
  5. Cover caps for wheel bolts
  6. Wheel bolts

Note

Make sure the correct wheel bolts are fitted → Electronic Parts Catalogue "ETKA"

Observe installation notes
  1. Hub cover
    • Remove and install