Wheel bolts
Wheel bolts, variants
Explanation of wheel bolt seat shapes
There are basically two seat shapes: the spherical seat and the conical seat.
The spherical seat is the curved surface of a spherical segment –arrow A–. This seat shape is used for original wheels.
The conical seat is the flat surface of a conical segment –arrow B–. This seat shape is partly used for wheels from the aftermarket.
- Wheel bolt with spherical seat
- Wheel bolt with conical seat
Note
- Make sure the correct wheel bolts are fitted → Electronic Parts Catalog "ETKA"
- Only the same wheel bolts may be used on all four wheels of a vehicle.

Standard, one-piece wheel bolt.

Two-piece wheel bolt with short swivel cap.

Two-piece wheel bolt with long swivel cap.

Wheel bolts, anti-theft wheel bolt
Anti-theft wheel bolt
- Anti-theft wheel bolt
- Cover cap
- Adapter for wheel bolt

Wheel bolts, master sets for anti-theft wheel bolts
Required Special Tools, Test and Measuring Equipment and Auxiliary Items
- Torque Wrench -V.A.G 1332-
- Master set for wheel bolts -T10101-

- Master set for wheel bolts -T10101 A-

- Master set for wheel bolts -T40004-

- Master set for wheel bolts -T40073-

Snow chains
Fitting and use of snow chains
Snow chains may only be fitted to the drive wheels.
However, on all-wheel drive vehicles, only the front wheels may be fitted with snow chains.
Snow chains are not possible with all wheel/tire combinations. See the vehicle tables in the expert opinion (Gutachterliche Stellungnahme) for details.
If no specific snow chain design is prescribed, fine-link snow chains may be used. On the tire tread and on the inner sides, including the chain lock, they must not protrude more than 15 mm.
On some models, only special fine-link snow chains are possible with certain wheel/tire combinations. See the vehicle tables in the expert opinion (Gutachterliche Stellungnahme) for details.
The legally permitted maximum speed when driving with snow chains is 50 km/h.
When driving on snow-free roads, the chains should be removed. They then serve no purpose, as handling becomes worse. The tires are subjected to unnecessary stress and chain wear is above average.
Temporary spare wheels
Notes on temporary spare wheels
If required, inform the customer of the following notes and, where appropriate, refer them to the owner's manual of their vehicle.
The following notes also apply to spare wheels marked with a yellow sticker reading "MAX 80 km/h" or "MAX 50 mph".
Note
- Depending on vehicle equipment, a spare wheel with the sticker described above is carried in the vehicle instead of the temporary spare wheel.
- The temporary spare wheel/spare wheel is intended for temporary, short-term use only. It must therefore be replaced with the standard wheel as soon as possible.
- After fitting the temporary spare wheel/spare wheel, check the tyre inflation pressure as soon as possible.
- Tire inflation pressures are shown on the tire inflation pressure label on the inside of the fuel filler flap or on the driver's side B-pillar.
- Always observe the speed limit markings on the temporary spare wheel ("MAX 80 km/h" or "MAX 50 mph").
- Avoid full-throttle acceleration, heavy braking and fast cornering.
- Snow chains must not be fitted to the temporary spare wheel for technical reasons.
- If driving with snow chains is necessary, then in the event of a front wheel puncture, fit the temporary spare wheel on the rear axle. The freed rear wheel must then be fitted in place of the defective front wheel.
For part numbers, refer to the → Electronic Parts Catalogue "ETKA".
