Interior body assembly work

Seat Belt Wearing Detection

~1min read

Removing and installing seat occupancy sensor


Note

The passenger seat occupancy sensor -G128- is only installed in the front passenger seat.

Removing


WARNING!

  • Observe the safety regulations for pyrotechnic components.
  • Before handling pyrotechnic components (for example, disconnecting the electrical connector), the person handling them must "discharge static electricity". For example, briefly touch the door striker.

- On e-up! vehicles, disconnect service plug for high-voltage system -TW-.

- Disconnect battery ground cable with ignition switched on → Electrical system.

- Remove front seat.

- Remove front seat belt buckle.

- Remove trim on front seat.

- Remove backrest of front seat.

- Remove cover and padding from seat pan.

VW UP. Karosserie-Montagearbeiten Innen

- Unclip clips -1- from seat frame.

- Remove seat occupancy sensor -3- with circuit board -3- from seat frame.

VW UP. Karosserie-Montagearbeiten Innen

Installing


WARNING!

  • Observe the safety regulations for pyrotechnic components.
  • Before handling pyrotechnic components (for example, connecting the electrical connector), the person handling them must "discharge static electricity". To do this, briefly touch the door striker plate, for example.

Installation is performed in the reverse order of removal, observing the following:


Note

Make sure the electrical connectors are pushed fully home until they audibly engage.


WARNING!

The battery must be reconnected with the ignition switched on. Improper repair work on pyrotechnic components (for example airbag, belt tensioner) can cause unintended deployment after the battery is reconnected. No person may be inside the vehicle cabin when reconnecting the battery.

- On e-up! vehicles, connect service plug for high-voltage system -TW-.

- Connect battery ground cable with ignition switched on → Electrical system.


Note

If the airbag warning lamp -K75- signals a fault after installation, the event memory must be read, erased and read again → Vehicle Diagnostic Tester.

VW UP. Karosserie-Montagearbeiten Innen