Airbag control module
Assembly overview - Airbag control module

- Electrical connector
- Airbag control module -J234-
- Remove and install
- The control module ground connection is made via the housing to the body.
- Nut
- 3 pieces
- 9 N·m
- The threads must be free of paint and dirt.
- The nuts and ground bolts serve as the ground connection for the control module.
Removing and installing airbag control module
Removing
![]()
WARNING!
Observe the safety regulations for pyrotechnic components.
- On e-up! vehicles, disconnect service plug for high-voltage system -TW-.
- Disconnect battery ground cable with ignition switched on → Electrical system.
- Remove center console.

- In the footwell on the driver side, unscrew nut -1-.
- Discharge static electricity. Briefly touch the body or the door striker plate.
- Open locking clip on connector -arrow- and pull off electrical connector -5-.
- In the footwell on the passenger side, unscrew nuts -3- and -4-.
- Lift airbag control module -2- off the threaded studs and remove it toward the passenger side.
Installing
![]()
WARNING!
- Observe the safety regulations for pyrotechnic components.
- Before handling pyrotechnic components (for example, connecting the electrical connector), the person handling them must "discharge static electricity". To do this, briefly touch the door striker plate, for example.
Installation is carried out in the reverse order, observing the following:
![]()
Note
Make sure the electrical connectors are pushed fully home until they audibly engage.
![]()
WARNING!
The battery must be reconnected with the ignition switched on. Improper repair work on pyrotechnic components (for example airbag, belt tensioner) can cause unintended deployment after the battery is reconnected. No person may be inside the vehicle cabin when reconnecting the battery.

- On e-up! vehicles, connect service plug for high-voltage system -TW-.
- Connect battery ground cable with ignition switched on → Electrical system.
![]()
Note
- If the airbag warning lamp -K75- signals a fault after installation, the event memory must be read out, erased and then read out again → Vehicle diagnostic tester.
- After replacing airbag control module -J234-, the control module must be coded → Vehicle diagnostic tester.
- The ground connection of airbag control module -J234- is made via the housing to the body.
Installation notes: for example tightening torques, replacing components
