Interior body assembly work

Side airbags

7steps
~42min
2/5difficulty
0102030405086N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Assembly overview - Front side airbag

VW UP. Karosserie-Montagearbeiten Innen

  1. Hook, bottom
    • for securing side airbag to backrest frame
  2. Hook, center
    • for securing side airbag to backrest frame
  3. Hook, top
    • for securing side airbag to backrest frame
  4. Front side airbag with igniter for driver side airbag -N199-
    • Passenger side: front side airbag with igniter for passenger side airbag -N200-


WARNING!

Observe the safety regulations for pyrotechnic components.

Remove and install
  1. Bolt
    • 8 N·m
  2. electrical wiring harness
    • from igniter for driver side airbag -N199- / igniter for passenger side airbag -N200- to connector station
  3. Backrest frame

Removing and installing front side airbag with igniter

Igniter for driver side airbag -N199- / igniter for passenger side airbag -N200-

Removing


WARNING!

  • Observe the safety precautions when working with pyrotechnic components.
  • Observe the additional safety regulations for side airbags.
  • Observe the regulations regarding storage, transport and disposal of airbag, belt tensioner and battery disconnect units (pyrotechnic components).

- Remove front seat.

- Pad the backrest cover in the area of the side airbag until the side airbag is fully accessible.

- Unscrew bolt -6-.

- Unhook the side airbag -5- from the backrest frame using hooks -2, 3, 4- and remove it.


WARNING!

Before handling pyrotechnic components (for example, disconnecting the electrical connector), the person handling them must "discharge static electricity". For example, briefly touch the door striker.

- Carefully pull out the connector lock with a small screwdriver and disconnect the electrical connector.

- The electrical wiring harness -1- from the side airbag remains on the seat.

Installing

Installation is carried out in the reverse order, observing the following:


WARNING!

  • Observe the safety regulations for pyrotechnic components.
  • Before handling pyrotechnic components (for example, connecting the electrical connector), the person handling them must "discharge static electricity". To do this, briefly touch the door striker plate, for example.

Installation notes: for example tightening torques, replacing components

VW UP. Karosserie-Montagearbeiten Innen