Clockspring. Removal and Installation

Removal

1. 1
   Remove the steering wheel.
   REFER TO: Steering Wheel (211-04 Steering Column, Removal and Installation).
2. 2
   Remove the steering column shrouds.
   Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation).
3. 3
   
   Remove the clockspring.
   

   1. Release the clip.

   2. Release the clip.

   3. Release the clip.

   4. Disconnect the electrical connector and remove the clockspring.

   

Installation

NOTICE: When installing a new clockspring, do not remove the clockspring rotation locking pin until the steering wheel is installed. If the rotation locking pin was removed before installing the steering wheel, the clockspring must be centered. Failure to follow this instruction may result in component damage and/or system failure.

1. 1
   Refer to: Clockspring Adjustment (501-20B Supplemental Restraint System, General Procedures).
2. 2
   To install, reverse the removal procedure.
3. 3
   Install the steering wheel.
   Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation).