Steering Gear - Removal

~1min read
1special tools


STEERING GEAR - COMPONENTS

REMOVAL

1. Снимите впускной воздушный шланг двигателя в сборе.

1. Remove the engine air intake hose assembly.

2. Disconnect the pressure and return hose retainers of the power steering hydraulic system.

3. Drain the working fluid from the power steering hydraulic system.

4. Disconnect the pressure and return tubes from the steering gear fittings.

5. Отсоедините карданный вал рулевого управления от рулевого механизма внутри

5. Disconnect the steering universal joint from the steering gear inside the passenger compartment.

6. Remove the band clamp and push out the steering shaft boot, then remove the boot support plate.

7. Raise the vehicle.

8. Remove the front wheels.

9. Извлеките шплинт, отверните гайку крепления и отсоедините шаровой шарнир наконечника

9. Remove the cotter pin, remove the nut and disconnect the steering tie rod end ball joint from the steering knuckle using special tool (09568-31000).

10. Снимите правый кронштейн крепления стабилизатора поперечной устойчивости.

10. Remove the right stabilizer bar mounting bracket.

11. Снимите передний глушитель в сборе.

11. Remove the front muffler assembly.

12. Снимите скобы крепления рулевого механизма и фиксаторы нагнетательной и возвратной

12. Remove the steering gear mounting brackets and the pressure and return tube retainers.

13. Извлеките рулевой механизм в сборе через арку правого переднего колеса.

13. Remove the steering gear assembly through the right front wheel arch.

When removing the steering gear assembly, remove it slowly and very carefully to avoid damaging the steering rod boots and the tie rod end ball joint boots.

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.