Hyundai Genesis DH Quiz
Brake System

Steering Angle Sensor Description and Operation

In this manual: Brake System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
7steps
~47min
3/5difficulty
1special tools
0204060801004936N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Description

The steering angle sensor detects the rotation direction of the steering wheel. The rotation direction detected by the sensor is sent to the HECU as a CAN signal via CAN communication. The HECU determines the steering wheel rotation speed and angle with this CAN signal. The HECU also uses this signal as an input signal for the yaw stability control.
  1. Disconnect the negative battery cable and wait at least 30 seconds.
  2. Turn the steering wheel so that the front wheels are aligned in a straight line.
  3. Remove the DAB module. (Refer to Restraints - Airbag Module)
  4. Disconnect the connector and the lock bolt (A), then remove the steering wheel using the special service tool (09561-11001).

    Tightening torque: 39.2 ~ 49 N·m
    Tighten the lock bolt appropriately and install the SST (09561-1101) to easily remove the steering wheel.
    Do not strike the steering wheel to remove it; this may damage the steering column. Do not reuse the steering lock bolt when installing.
  5. Remove the steering column shroud. (Refer to Body - Steering Column Shroud Panel)
  6. Remove the clockspring.
  7. Install in the reverse order of removal.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.