Hyundai Genesis DH Quiz
Brake System

Steering Angle Sensor Repair Procedures

In this manual: Brake System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
4steps
~24min
2/5difficulty
Done 0 of 4

Adjustment

Calibration (Zero Angle Setting) The absolute type steering angle sensor (CAN type) measures the angle based on the zero reference of the angle set. Calibration must be performed in the following cases:
  • Steering Angle Sensor Replacement
  • Steering Column Replacement or Repair
  • DTC (C1260, C1261) Detection
  • Sensor Block Replacement
  • HECU Replacement
Calibration Procedure Perform wheel alignment and set the steering wheel to the straight-ahead position within ±5°.
  1. Connect GDS. (CAN line or OBD connector)
  2. Turn the ignition on.
  3. Press the steering angle sensor calibration button.
  4. Perform the HECU calibration procedure. (Calibration records, DTC erasure)

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.