Hyundai Kona Quiz
Engine Control System/Fuel System

Fuel Pump Motor Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
11steps
~66min
3/5difficulty
Done 0 of 11

Removal

  1. Remove the fuel pump. (Refer to Fuel System - "Fuel Pump")
  2. Disconnect the fuel pump motor connector (A) and the fuel level sensor connector (B).
  3. Press the locking hook (A) with a screwdriver and remove the fuel level sensor (B) in the direction of the arrow.
  4. Remove the fuel feed tube (B) after removing the retaining clip (A).
  5. Remove the head assembly (D) after releasing the locking hooks (C).
  6. Remove the reservoir cup (B) after releasing the locking hooks (A).
  7. Disconnect the ground cable (A).
  8. Disconnect the fuel pump motor connector (B).
  9. Remove the stopper pin (A), then remove the fuel pressure regulator (B).
  10. Remove the pre-filter (B) by releasing the locking hooks (A).
  11. Remove the fuel pump motor (B) in the direction indicated by the arrow.

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.