Hyundai Kona Quiz
Engine Control System/Fuel System

Fuel Pressure Sensor (FPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
8steps
~48min
2/5difficulty
Done 0 of 8

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Check the output voltage of the Fuel Pressure Sensor (FPS).
Pressure
[kPa (kgf/cm², psi)]		 Output voltage (V)
50 (0,51, 7,3) 0,3
600 (6,12, 87,0) 2,5
1100 (11,2, 159,5) 4,5

Removal

  1. Turn the ignition off, and then disconnect the negative (-) battery terminal.
  2. Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly")
  3. Remove the fuel pump service cover (A).
  4. Disconnect the fuel pressure sensor connector (A).
  5. Remove the fuel pressure sensor lock pin (B).
  6. Remove the fuel pressure sensor from the fuel pump.

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.