Hyundai Kona Quiz
Engine Control System/Fuel System

Delivery Pipe Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
3/5difficulty
0102030405023.517N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Removal

  1. Release the residual fuel pressure in the fuel line. (Refer to Fuel System - "Release Residual Fuel Pressure in Line")
  2. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  3. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold")
  4. Remove the high-pressure fuel hose (A).
  5. Disconnect the injector connectors (A) and the rail pressure sensor connector (B).
  6. Remove the mounting bolt (D), then remove the delivery pipe and injector assembly from the engine.

Installation

  1. Install in the reverse order of removal. Delivery pipe mounting bolt: 18.6–24 N·m High-pressure fuel line flange nut: 26.5–32 N·m

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.