Output Speed Sensor

Description and Operation

Description

The output speed sensor is a vital device that measures the rotation speed of the transaxle output shaft and turbine shaft and outputs a signal to the TCM.

Specifications

Specifications

▶ Type: Hall Sensor

Operating Conditions [°C (°F)]		(-40~150) -40~302
Output Voltage	High	1,18~1,68
	Down	0,59~0,84

Circuit Diagrams

Wiring Diagram

Repair Procedures

Inspection

1. Use GDS to monitor the input/output speed sensor output signals.
   • Turn the ignition switch to the OFF position.
   • Connect the GDS to the Data Link Connector (DLC) located under the instrument panel.
   • Ignition switch ON and engine ON.
   • Check the input/output speed sensor signal waveforms at high and low speed.
   Fig. 1) Input/Output Low Speed Sensor

   

   Fig. 2) Input/Output Low Speed Sensor

   

DEPOSIT

1. 1
   Remove the valve body. (Refer to Hydraulic System - "Valve Body")
2. 2
   Disconnect the input and output speed sensor connector (A) from the main harness.
3. 3
   Remove the input and output speed sensor (B) after removing the bolts (2 pcs).

   Tightening torque: 9.8–11.8 N·m

   

REMEDY

1. 1
   To install, perform the removal procedure in reverse order.
2. 2
   After filling the automatic transmission with fluid, check the fluid level. (Refer to Hydraulic System - "Fluid")