Hyundai Tucson Quiz
AUTOMATIC TRANSMISSION SYSTEM

Shift lever

In this manual: AUTOMATIC TRANSMISSION SYSTEM
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
15steps
~90min
4/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 15

Components and Component Location

Component location

1. Shift knob assembly and boot
2. Shift lever assembly
3. Shift cable		 4. Manual control lever
5. Shift cable retainer
6. Lock pin

COMPONENTS

1. Shift lever and boots
2. Shift lever assembly
3. P position switch
4. P position switch mounting bracket		 5. Shift lock solenoid
6. Main connector
7. Manual mode switch housing
8. Damper

Circuit Diagrams

Schematic Diagrams

Repair Procedures

DEPOSIT

  1. Pull the knob (A) in the direction "F" and remove the knob.
  2. Remove the floor console assembly. (Refer to Body group - "Floor Console")
  3. Remove the air duct (A).
  4. Disconnect the connector (A) from the shift lever.
  5. Disconnect the wiring clamp (A).
  6. Remove the snap ring (A).
  7. Disconnect the control cable.
    1. Disconnect the cable bracket (A) from the shift lever.
    2. Disconnect the shift cable bracket (B) after pressing the lock.
  8. Remove the bolts and the shift lever assembly (B).

    Tightening torque: 8.8 - 13.7 N·m

  9. Remove the P position switch mounting bracket (A).
  10. Disconnect the P position switch (A) and the shift lock solenoid of the shift lever (B).
  11. Disconnect the main connector (C) from the shift lever.
  12. Disconnect the manual mode switch housing (A).
  13. P position switch, shift lock solenoid, manual mode switch housing, main connector (B).
  14. Remove the mounting bracket (A) from the main connector terminals.
  15. Disconnect each connector (F) of the position switch P (A) from the solenoid. Remove the shift lock (B), the manual mode switch housing (C), and then the main connector (D) after removing the lock (E).

REMEDY

  1. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.