Hyundai Tucson Quiz
Engine/Fuel Control System

Repair Procedures

In this manual: Engine/Fuel Control System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the MAPS output voltage at idle and with the ignition switch ON.

    Specification: Refer to "Specifications"

DEPOSIT

  1. Turn the ignition switch to the OFF position and disconnect the negative (-) battery cable.
  2. Disconnect the manifold absolute pressure sensor connector (B).
  3. Loosen the installation bolt (B), then remove the balance tank sensor.

REMEDY

  1. To install, reverse the removal procedure. MAP sensor mounting bolt: 9.8 – 11.8 N·m

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.