Kawasaki Ninja ZX-10R Quiz
Self-Diagnosis System

Idle Speed Control Valve Actuator Resistance Inspection

In this manual: Self-Diagnosis System
General Information — 26Periodic Maintenance — 66Fuel System (DFI) — 79Cooling System — 28Engine Top End — 51Clutch — 24Engine Lubrication System — 28Engine Removal/Installation — 5Crankshaft/Transmission — 65Wheels/Tires — 22Final Drive — 17Brakes — 54Suspension — 36Steering — 17Frame — 40Electrical System — 104Self-Diagnosis System — 112Appendix — 10
~1min read
  • Turn the ignition switch to OFF.
  • Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter).
  • Disconnect the idle speed control valve actuator connector [A].
Idle Speed Control Valve Actuator Resistance Inspection

  • Connect a digital meter to the idle speed control valve actuator connector [A]
  • Measure the idle speed control valve actuator resistance.

Idle Speed Control Valve Actuator Resistance Connections: G/R lead [1] ←→ G/BK lead [4] G/O lead [2] ←→ G/Y lead [3] Standard: About 64 96 Ω


Idle Speed Control Valve Actuator Resistance Inspection

If the reading is out of the standard, replace the idle speed control valve actuator.

If the reading is within the standard, check the input voltage (see Idle Speed Control Valve Actuator Input Voltage Inspection).

Test yourself

A quick Kawasaki Ninja ZX-10R quiz: every answer comes with an explanation and a link to the manual page.