Kia Forte BD Quiz
Body (Interior and Exterior)

Rear Bumper Assembly

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 32Engine Mechanical System — 47Engine Electrical System — 17Emission Control System — 10Engine Control System/Fuel System — 32Clutch System — 11Manual Transmission — 11DCT (Dual Clutch Transmission) System — 16Drive Shaft and Axle — 8Suspension System — 26Steering — 9Restraints — 11Brake System — 27Body (Interior and Exterior) — 119Body Electrical System — 98Heating, Ventilation, and Air Conditioning — 27
17steps
~102min
5/5difficulty
Done 0 of 17

Components and Component Location

Component Location

[4 Door]

1. Rear Bumper Assembly

[5 Door]

1. Rear Bumper Assembly

Repair Procedures

Replacement

[4 Door]

  1. Remove the combination lamp cover (A).

  2. Disconnect the mounting nuts and the rear combination lamp connector (A).

  3. Remove the rear combination lamp (A).

  4. Loosen the mounting clips and nuts, then remove the rear bumper latch cover (A).

  5. Loosen the mounting bolts.

  6. Disconnect the rear bumper connector (A).

  7. After loosening the pin clips and screws on the side, disconnect the side of the rear bumper assembly.

  8. Loosen the upper clips and mounting screws of the rear bumper.

  9. To install, reverse the removal procedure.

[5 Door]

  1. Loosen the mounting screws and remove the rear combination lamp (A).

  2. Press the lock pin and disconnect the rear combination lamp connector (A).

  3. Loosen the mounting screws and the side clip of the rear bumper (A), then disconnect the side part of the rear bumper.

  4. Loosen the lower rear bumper mounting clips.

  5. Remove the lower mounting bolts of the rear bumper.

    [LH]

    [RH]

  6. Loosen the retainer clips and screws, then remove the rear bumper assembly (A).

  7. Press the stopper pin and disconnect the main connector (A) of the rear bumper.

  8. To install, reverse the removal procedure.

Test yourself

A quick Kia Forte BD quiz: every answer comes with an explanation and a link to the manual page.