Battery Temperature Sensor Repair procedures
Removal
Shut off the high voltage circuit.
(Refer to Hybrid Control System - “High Voltage Shutoff Procedure”)
Remove the high voltage battery pack assembly.
(Refer to High Voltage Battery System - "Battery Pack Assembly")
Remove the high voltage battery pack assembly rear cover (A) after loosening the mounting nuts.

Remove the battery temperature sensor (A).

Installation
Install the battery temperature sensors in the reverse order of removal.
Inspection
Shut off the high voltage circuit. (Refer to “High Voltage Shutoff Procedure”.)
Connect the KDS/GDS to the Data Link Connector (DLC).
Switch "ON" the ignition.
Check the battery temperature in KDS/GDS service data.

Disconnect the battery temperature signal connector (A).

Measure resistances of the temperature signal terminals (Refer to the table below), then compare the value with the KDS/GDS service data.
Item Terminals Battery temperature sensor (B06-05) [High voltage battery module #5] BMS ECU B01-T(1),(7) Battery temperature sensor (B06-09) [High Voltage battery module #9] BMS ECU B01-T(2),(8) Inlet temperature sensor (B06) BMS ECU B01-T(4),(10)
Specification: Refer to “Specification”