Hybrid Control System
Pre-Charge Relay Description and operation
In this manual: Hybrid Control System
~1min read
Description
Built into the Power Relay Assembly (PRA), the Pre-Charge Relay starts to charge the capacitor of the inverter soon after ignition "ON", then it goes out when the capacitor has been fully charged.

| 1. High Voltage Power Terminal (-) 2. High Voltage Power Terminal (+) 3. Battery Current Sensor 4. Inverter Power Terminal (-) 5. Inverter Power Terminal (+) 6. Pre-Charge Resistor |
7. Main Relay (+) 8. Pre-Charge Relay 9. Main Relay (-) 10. Power Relay Assembly Connector (Battery current sensor signal input) 11. Power Relay Assembly Connector (Main relay control) |
[PRA Operation Sequence]


Was this page helpful?