Main Fuse Repair procedures
Removal
Switch "OFF" the ignition and disconnect the negative (-) terminal of the auxiliary 12V battery.
Remove the safety plug cover (A).

Unfasten the hook (A) in the direction of arrow.

Unfasten the lever (A) in the direction of arrow.

Remove the safety plug (A).

Remove the safety plug lever (A).
Remove the main fuse (C) after removing the safety plug cover (B).

Inspection
Method 1
Remove the safety plug.
(Refer to High Voltage Battery Control System - "Safety Plug")
Check the continuity between ends of the safety plug.

S pecification : Less than 1Ω (20 °C)
If the measured resistance is not within the specifications, then replace the main fuse according to the maintenance guideline.
Method 2
Remove the safety plug.
(Refer to High Voltage Battery Control System - "Safety Plug")
Remove the main fuse.
(Refer to "Removal")
Check the continuity between ends of the main fuse.

Specification : Less than 1Ω (20 °C)
If the measured resistance is not within the specifications, then replace the main fuse according to the maintenance guideline.
Installation
Install the main fuse in the reverse order of removal.