Engine Control/Fuel System

Delivery Pipe Repair procedures

7steps
~42min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Removal

  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System -"Release Residual Pressure in Fuel Line").

  2. Switch "OFF" the ignition and disconnect the negative (-) terminal of the auxiliary 12V battery.

  3. Remove the intake manifold.

    (Refer to Engine Mechanical System - "Intake Manifold")

  4. Remove the high pressure pipe flange nuts (A) by using the special service tool [SST No. 09314 - 3Q100 or 09314 - 27130].

  5. Remove the high pressure fuel pipe (C) after loosening the function block mounting bolt (B).

    High pressure fuel pipe function block mounting bolt:

    9.8 - 11,8 N·m

    High pressure fuel pipe flange nut:

    26.5 - 32 N·m

  6. Remove the delivery pipe & injector assembly mounting bolts (A).

    Delivery pipe & injector assembly mounting bolt:

    18.6 - 24 N·m

  7. Remove the delivery pipe & injector assembly (A) from the engine.

Installation

  1. Install in the reverse order of removal.