Release residual pressure in fuel line
Release Residual Pressure in Fuel Line
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
Remove the fuel pump fuse (A).

Reconnect the negative (-) battery terminal.
Run the engine for about one minute to lower the pressure in the low pressure line.
Switch "OFF" the engine.
Disconnect the low pressure fuel line quick connector at the High Pressure Pump. Use rags to cover opening and catch spills while removing the fuel line.
Start the engine and let it idle until the engine stops. At this point the pressure should be under 30 psi.
Proceed with the service or repair. Use rags to cover opening and catch spills when opening up the high pressure system.
Reinstall / re-connect all components in reverse order of removal. Start engine and confirm proper operation, and make sure there are no fuel leaks.
After completing, clear DTC(s) using KDS/GDS scan tool (the procedure described above will cause DTC to set).