Engine Control/Fuel System

Fuel Pump Control Module (FPCM) Repair procedures

13steps
~83min
4/5difficulty
1special tools
Done 0 of 13

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Remove the rear seat cushion.

    (Refer to Body - "Rear Seat Assembly")

  3. Fuel pump service cover (A).

  4. Remove the fuel pump control module connector (A).

  5. Disconnect the fuel pressure sensor connector (B).

  6. Disconnect the fuel feed tube quick-connector.(C).

  7. Remove the fuel pump plate cover (B) by using the special service tool (A) [SST NO.:09310-B8100].

  8. Remove the fuel pump (A).

Installation

  1. Install in the reverse order of removal.

Inspection

  1. Connect the KDS/GDS to the vehicle's data link connector (DLC).

  2. Check for DTCs and repair any according to the DTC guide.

  3. Check the power supply voltage provided to the fuel pressure sensor (FPS).

    Specification: 5V

  4. Check the voltage provided to the fuel pressure sensor (FPS) at idle.

    Specification: 1.9 - 3.2 V

  5. Check the fuel pressure in the low fuel line.

    (Refer to Fuel Delivery System - "Fuel Pressure Test")